TinyShield Proto Board


80 in stock

  • Free Shipping for orders over $50
  • Available Worldwide


    This proto board brings all of the TinyShield signals out to a point that you can solder to. All of the signals are marked and are spaced with 0.1″ spacing (same spacing as on the standard Arduino Uno), so a standard 0.1″ header can be used if desired.

    This proto board can be ordered with or without a top stackable connector. By default, a top connector is not needed since the standard method is to use this proto board as the top board in a TinyDuino stack for the easiest access to the signals. However, when this board is ordered with the top stackable connector, it can be an inner layer of the TinyDuino stack (which can be useful in some projects).

    Note:This TinyShield replaces all of the older style Proto1, Proto2 and Proto3 boards, which have been discontinued.

    To learn more about the TinyDuino Platform, click here


        Pins Supported

        • All Shield signals supported
        • VCC, VBATT,+3V3, +5V, VIN, GND, RSV2, RSV1, RSV0, RESET, 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, SS, MOSI, MISO, SCK, AREF, A0, A1, A2, A3, A4/SDA, A5/SDL


        • 20mm x 20mm (.787 inches x .787 inches)
        • Max Height (No Top Connector): (from lower bottom TinyShield Connector to upper PCB level): 2.81mm (0.111 inches)
        • Max Height (With Top Connector): (from lower bottom TinyShield Connector to upper PCB level): 5.11mm (0.201 inches)
        • Weight (No Top Connector): 0.70 grams
        • Weight (With Top Connector): 0.85 grams


        • When using soldered wires, take care not to allow this to short out to boards above or below in the stack (ie, some pins could short out to the USB connector if the wires are long). If needed, use tape to insulate the solder connections.



        RC Aircraft Navigation Lights
        RC Aircraft Navigation Lights
        This project uses the TinyLily Mini or TinyDuino platform to add functional navigation lights to your flying radio control model.
        TinyHoverCraft Tutorial
        TinyHoverCraft Tutorial
        Learn how to build a hovercraft that you can control with any TV remote!

        Related Items

        Proto Terminal Blocks TinyShield
        Proto Terminal Blocks TinyShield
        This board makes prototyping with the TinyDuino simple without having to solder by using screw terminal blocks. Just place a wire into the signal t...
        Ribbon Cable Extender TinyShield
        Ribbon Cable Extender TinyShield
        This kit allows TinyShields to be spaced out apart from one another by using two flat flex ribbon cable boards and a flexible ribbon cable.