LRA Driver Wireling - TinyCircuits
Ambient Light Sensor Wireling compared to a dime
LRA Driver Wireling back view
LRA Driver Wireling

LRA Driver Wireling

AST1013

21 in stock
Regular price $ 14.95 Save $ -14.95

OR

This Wireling lets you control a Linear Resonant Actuator (LRA) motor via the I²C bus and the DRV2605 IC. The DRV2605 Haptic Driver chip includes a licensed library of over 100 pre-programmed waveforms that generate a variety of effects.

Use this Wireling to create haptic motor vibration effects. Due to the construction and operating method, LRAs outlast traditional vibration motors several times over and are tuned to operate at frequencies that are optimal for skin contact. 

LRA motor pictured is pre-soldered to the circuit board and includes a sticky adhesive that can be used to attach the motor to the back of the board or another surface. 

New to Wirelings? Check out the Wireling Overview!

Note* 5-Pin Wireling cables not included and sold separately.

    TI DRV2605 LRA Haptic Driver Specs

    • Flexible Haptic/Vibra Driver
      • LRA (Linear Resonance Actuator)
      • ERM (Eccentric Rotating Mass)
    • I2C Controlled Digital Playback Engine
      • Real-Time Playback Mode via I2C
    • Smart Loop Architecture(1)
      • Automatic Overdrive/Braking (ERM/LRA)
      • Automatic Resonance Tracking (LRA)
      • Automatic Actuator Diagnostic (ERM/LRA)
      • Automatic Level Calibration (ERM/LRA)
    • Licensed Immersion™ TouchSense® 2200
      features:
      • Integrated Immersion Effect Library
      • Audio to Vibe
    • Optional PWM Input with 0% to 100% Duty Cycle
      Control Range
    • Optional Analog Input Control
    • Optional Hardware Trigger Pin
    • Efficient Output Drive
    • Fast Start-Up Time
    • Constant Acceleration Over Supply Voltage
    • 1.8 V Compatible, VDD Tolerant Digital Pins

      TinyDuino Power Requirements

      • Voltage: 3.0V - 5.5V 
      • Current: 2.5mA

      Pins Used

      • A5/SCL - I²C Serial Clock line
      • A4/SDA - I²C Serial Data line

      Dimensions

      • 10mm x 10mm (.394 inches x .394 inches)
      • Max Height 7.07mm (0.278 inches)
      • Weight: 1 gram (.04 ounces)
      • You can also use this Wireling without the TinyDuino – modifying the connecting cable by removing the opposite connector and stripping/tinning the wires, you can solder the connector cable to any other microcontroller board of your choice!   


      Customer Reviews

      No reviews yet
      0%
      (0)
      0%
      (0)
      0%
      (0)
      0%
      (0)
      0%
      (0)