Using the Seven Segment LED TinyShield Tutorial

by TinyCircuits Staff February 18, 2016

Using the Seven Segment LED TinyShield Tutorial

The TinyShield Seven Segment LED board contains two seven segment LEDs(Red LEDs) that can be set over the I2C bus(thus saving signals to do other tasks) by using a Semtech SX1506 I/O expander.

A basic example Arduino sketch that works with the TinyDuino and TinyShield Seven Segment LED board is shown below:



TinyCircuits Staff
TinyCircuits Staff

Author



Also in Learn

TinyZero Accelerometer BMA250 Internet of Things Project with Cayenne
TinyZero Accelerometer BMA250 Internet of Things Project with Cayenne

by Laverena Wienclaw November 21, 2018

In this tutorial, we will use Cayenne to capture some accelerometer readings on their nice Internet of Things dashboard

View full article →

TinyZero Setup Tutorial
TinyZero Setup Tutorial

by Laverena Wienclaw November 21, 2018

Ready to get started with your new TinyCircuits product? This tutorial will cover basic setup of the TinyZero.

View full article →

Using the TinyZero Accelerometer
Using the TinyZero Accelerometer

by Laverena Wienclaw November 21, 2018

This tutorial will guide you through reading values from the Accelerometer that can be populated on the TinyZero

View full article →